The EMR-H features a slightly curved button surface to fit the
natural curvature of your finger. The
form fitting curve, along with horizontal serrations, create a self centering
surface that inhibits the finger's vertical movements. The EMR-H has a milspec through hole for the
magazine catch's shaft, and is only 0.02" taller than the factory magazine
release button. When installed, the EMR-H has minimal protrusion above the mag release button fence on most forged receivers.
Machined from 4140 bar stock, it is QPQ coated.
In late 2019, 7075 aluminum EMR was replaced by 4140 steel EMR-H
(heavy). EMR-H joins the MSQ-H (MLOK, Sling Adapter, Heavy) and ESF-H
(End plate, Sling adapter, Heavy) in the H (heavy) line of components.
Please visit the FCD EMR vs EMR-C page for an in depth review of the differences between the EMR-H and EMR-HC.
in the USA.